Table of Contents
Advertisement
414
SERVICING AND MAINTENANCE
REAR TAIL/STOP, TURN SIGNAL AND
BACKUP LAMPS
See the following steps to replace:
1.
Remove the two screws and pushpins that pass
through the bed sheet metal.
Tail Lamp Locations
1 — Tail Lamp
2 — Screws
3 — Fasteners
2.
Pull the outboard side of the lamp rearward far
enough to unsnap the two receptacles on the
outboard side of the lamp housing from the two
plastic snap post retainers in the outer box side
panel.
Tail Lamp Removed
3.
Disconnect the wiring harness connectors from the
bulb socket.
4.
Rotate the bulb socket counterclockwise a quarter
turn to unlock it from the housing.
5.
Pull the bulb straight out of the socket.
CAUTION!
Do not contaminate the bulb glass by touching it with
your fingers or by allowing it to contact other oily
surfaces. Shortened bulb life will result.
6.
Reverse the procedure to install the bulb and
housing.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
WITH CARGO LAMP
See the following steps to replace:
1.
Remove the two screws holding the housing/lens to
the body as shown.
CHMSL Mounting Screw Locations
2.
Separate the connector holding the housing and
wiring harness to the body.
3.
Turn the desired bulb socket a quarter turn and
remove the socket and bulb from housing.
Advertisement
Table of Contents
