Table of Contents
Advertisement
NOTE:
Dual wheels are flat mounted, center piloted. The lug nuts
are a two-piece assembly. When the tires are being
rotated or replaced, clean these lug nuts at the interface
between the lug nut/bolt and the washer. Do not oil wheel
studs.
Two-Piece Lug Nut
Inspect the wheel mounting surface prior to mounting the
tire and remove any corrosion or loose particles.
Wheel Mounting Surface
Retighten the wheel nuts, in the same pattern, to the
torques listed in the Torque Specifications table. Go
through the sequence a second time to verify that the
specific torque has been achieved. Retighten to
specifications after 25 miles (40 km) and check the lug
nut/bolt torque to be sure that all the lug nuts/bolts are
properly tightened.
TECHNICAL SPECIFICATIONS
8/10 Lug Nuts/Bolts Torque Patterns
1 — 10 Bolt Pattern
2 — 8 Bolt Pattern
It is recommended that wheel stud nuts be kept torqued
to specifications at all times. Torque wheel stud nuts to
specifications at each lubrication interval.
439
9
Advertisement
Table of Contents
