Table of Contents
Advertisement
194
STARTING AND OPERATING
The system is deactivated in the following conditions if it
was activated manually from the Uconnect controls menu
via the Surround View button, Back Up Camera button,
Cargo Camera button or Forward Facing Camera button:
The touchscreen X button on the display is pressed
Vehicle is shifted into PARK
Ignition is placed in the OFF position
Vehicle speed is over 8 mph (13 km/h) for 10 seconds
NOTE:
If the Surround View Camera, Cargo Camera, Back Up
Camera, or Forward Facing Camera is activated manually,
and the vehicle is shifted into REVERSE, deactivation
methods for automatic activation are assumed.
The camera delay system is turned off manually through
the Uconnect Settings menu
page 226.
Ú
NOTE:
If snow, ice, mud, or any foreign substance builds up on
the camera lenses, clean the lenses, rinse with water,
and dry with a soft cloth. Do not cover the lenses.
If a malfunction with the system has occurred, see an
authorized dealer.
Cargo Camera With Dynamic Centerline — If Equipped
The Dynamic Centerline feature provides an overlay on the
Cargo Camera display screen that aligns to the center of
the pickup box to aid in hooking up a fifth-wheel camper or
gooseneck trailer. The centerline auto aligns to the center
of the pickup box, and can also be manually adjusted. The
centerline will adjust in response to steering angle inputs,
and will not obstruct the gooseneck receiver or an
approaching trailer gooseneck in the camera feed.
Activation
The Dynamic Centerline feature can be activated through
the Uconnect settings by pressing the Cargo Camera
button, followed by the Dynamic Centerline button on the
touchscreen.
If the Dynamic Centerline feature is turned on, the overlay
will display any time the Cargo Camera image is displayed.
Adjusting Centerline
To manually adjust the centerline, proceed as follows:
1.
Press the Adjust Centerline button located in the
bottom right corner of the Cargo Camera display.
2.
Use the arrows on the bottom left corner of the Cargo
Camera display to adjust the centerline horizontally
or vertically.
3.
Once the desired position is achieved, press the
Accept button to set the centerline to the newly
specified position.
Deactivation
The Dynamic Centerline feature will automatically be
deactivated whenever the Cargo Camera display is
deactivated. It can also be manually deactivated through
the Uconnect Settings.
Cargo Camera Zoom View
When the Cargo Camera image is being
displayed, and the vehicle speed is below
8 mph (13 km/h) while in any gear selector
position, Zoom View is available. By pressing
the "magnifying glass" icon in the upper left of the display
screen, the image will zoom in to four times the standard
view. Pressing the icon a second time will return the view
to the standard Cargo Camera display.
When Zoom View is selected while the vehicle is in
REVERSE, then shifted to DRIVE, the camera delay view
will display the standard Cargo Camera view. If the vehicle
is then returned to REVERSE gear from DRIVE, the Zoom
View selection will automatically resume.
Shifting to NEUTRAL from any gear will maintain the
selected view (Zoom or Standard) as long as the vehicle is
below 8 mph (13 km/h).
Zoom View is available until the gear selector is placed in
DRIVE or REVERSE and speeds are at or above 8 mph
(13 km/h).
NOTE:
If the vehicle is in DRIVE, NEUTRAL, or REVERSE, and
speed is greater than or equal to 8 mph (13 km/h),
Zoom View is unavailable and the icon will appear gray.
While in Zoom View, the dynamic centerline will not be
visible.
Advertisement
Table of Contents
