Table of Contents
Advertisement
Outer Front Park And Turn
See the following steps to replace:
1.
Open the hood.
2.
Disconnect and isolate the negative battery cable.
3.
Reach into the front wheel house ahead of the front
wheel, remove the fastener, and lift the cover over
the access hole in the front of the wheel house splash
shield. Access to the rear of the lamp can be gained
through this access hole.
Splash Shield Access Cover
4.
Reach through the access hole of the wheel house
splash shield and disengage the side marker socket
by rotating counterclockwise a quarter turn.
Park And Turn Sockets
5.
Pull the socket and bulb straight out from the
housing.
6.
Separate the bulb from the socket without twisting.
7.
Reverse the procedure for installation of new bulb
and covers.
FOG LAMPS — IF EQUIPPED
Please see an authorized dealer for service on LED and
Halogen front fog lamps.
SERVICING AND MAINTENANCE
Halogen
See the following steps to replace:
1.
Reach under and behind the front fascia/bumper to
access the back of the front fog lamp housing.
2.
Disconnect the fog lamp wiring harness connector
from the fog lamp bulb.
3.
Rotate the bulb counterclockwise a quarter turn to
unlock the bulb from the housing.
Fog Lamp Bulb
4.
Pull the bulb straight out from the housing.
CAUTION!
Do not contaminate the bulb glass by touching it with
your fingers or by allowing it to contact other oily
surfaces. Shortened bulb life will result.
413
8
Advertisement
Table of Contents
