Table of Contents
Advertisement
218
STARTING AND OPERATING
S
P
P
NOWPLOW
REP
ACKAGE
A
VAILABILITY
For Information about snowplow applications visit
www.ramtrucks.com or refer to the current Body Builder's
Guide.
1.
The maximum number of occupants in the truck
should not exceed two.
2.
The total GVWR or the Front GAWR or the Rear GAWR
should never be exceeded.
3.
Cargo capacity will be reduced by the addition of
options or passengers, etc.
The loaded vehicle weight, including the snowplow
system, all aftermarket accessories, driver, passengers,
options, and cargo, must not exceed either the Gross
Vehicle Weight Rating (GVWR) or Gross Axle Weight Rating
(GAWR). These weights are specified on the Safety
Compliance Certification Label on the driver's side door
opening.
NOTE:
Detach the snowplow when transporting passengers.
Vehicle front end wheel alignment was set to
specifications at the factory without consideration for the
weight of the plow. Front end toe-in should be checked
and reset if necessary at the beginning and end of the
snowplow season. This will help prevent uneven tire wear.
M
The blade should be lowered whenever the vehicle is
ODEL
parked.
Maintain and operate your vehicle and snowplow
equipment following the recommendations provided by
the specific snowplow manufacturer.
O
T
R
VER
HE
S
NOWPLOW
The blade restricts air flow to the radiator and causes the
engine to operate at higher than normal temperatures.
Therefore, when transporting the plow, angle the blade
completely and position it as low as road or surface
conditions permit. Do not exceed 40 mph (64 km/h).
The operator should always maintain a safe stopping
distance and allow adequate passing clearance.
O
T
PERATING
Under ideal snow plowing conditions, 20 mph (32 km/h)
should be maximum operating speed. The operator should
be familiar with the area and surface to be cleaned.
Reduce speed and use extreme caution when plowing
unfamiliar areas or under poor visibility.
O
W
OAD
PERATION
ITH
A
TTACHED
IPS
G
M
ENERAL
AINTENANCE
Snowplows should be maintained in accordance with the
plow manufacturer's instructions.
Keep all snowplow electrical connections and battery
terminals clean and free of corrosion.
When plowing snow, to avoid transmission and drivetrain
damage, the following precautions should be observed.
Operate with transfer case in 4WD LOW when plowing
small or congested areas where speeds are not likely to
exceed 15 mph (24 km/h). At higher speeds operate in
4WD HIGH.
Vehicles with automatic transmissions should use
4WD LOW when plowing deep or heavy snow for
extended periods of time to avoid transmission over-
heating.
Do not shift the transmission unless the engine has
returned to idle and wheels have stopped. Make a
practice of stepping on the brake pedal while shifting
the transmission.
Advertisement
Table of Contents
