Table of Contents
Advertisement
2.
Pull down on the first set of clamp handles to release
the clamps from the Stowed Position.
Stowed Position
3.
Push clamp wires up and under the flange of the box
(or flange of the RamBox rail, if equipped) to the
Semi-Clamped Position.
Semi Clamped Position
4.
Push clamp handles upward to the clamped position
to properly engage the clamps.
Clamped Position
NOTE:
Once clamped, be sure the clamps are not improperly
attached to the truck bed flange.
Improper Clamp Position
GETTING TO KNOW YOUR VEHICLE
5.
Disengage the stowage straps.
6.
Unfold the center and rear panels to the Intermediate
Position.
Intermediate Position (Vehicle Cannot Be Driven)
NOTE:
When folding the center and rear panels, the sections
MUST be held together to avoid damage to the cover
material.
Incorrect Folding — Will Cause Damage
89
2
Advertisement
Table of Contents
