Table of Contents
Advertisement
386
SERVICING AND MAINTENANCE
5.
Remove the cabin air filter by pulling it straight out of
the housing.
Cabin Air Filter
6.
Install the cabin air filter with the arrow on the filter
pointing toward the floor. When installing the filter
cover, press on each end until you hear an audible
click.
CAUTION!
The cabin air filter is identified with an arrow to indicate
airflow direction through the filter. Failure to properly
install the filter will result in the need to replace it more
often.
7.
Reinstall the glove compartment on the hinges.
8.
Pull the tension tether outward and reinstall the glove
compartment past the travel stops by pushing in on
the glove compartment sides.
Glove Compartment
1 — Glove Compartment Travel Stop
2 — Glove Compartment Tension Tether
3 — Glove Compartment Door
NOTE:
Ensure the glove compartment door hinges and glove
compartment travel stops are fully engaged.
9.
Reattach the glove compartment tension tether by
inserting the tether clip in the glove compartment and
sliding the clip away from the face of the glove
compartment door.
A
D
B
I
CCESSORY
RIVE
ELT
NSPECTION
WARNING!
Do not attempt to inspect an accessory drive belt
with vehicle running.
When working near the radiator cooling fan,
disconnect the fan motor lead. The fan is tempera-
ture controlled and can start at any time regardless
of ignition mode. You could be injured by the moving
fan blades.
You can be badly injured working on or around a
motor vehicle. Only do service work for which you
have the knowledge and the proper equipment.
If you have any doubt about your ability to perform a
service job, take your vehicle to a competent
mechanic.
Advertisement
Table of Contents
