Multiple Symbols; No Read; Video Reverse - Honeywell HH1800 User Manual

Multiple Symbols

When this programming selection is turned On, it allows you to read multiple symbols with a
single pull of the scanner's trigger. If you press and hold the trigger, aiming the scanner at a
series of symbols, it reads unique symbols once, beeping and or vibrating (if turned on) for
each read. The scanner attempts to find and decode new symbols as long as the trigger is
pulled. The maximum number of barcodes read is 21. When this programming selection is
turned Off, the scanner will only read the symbol closest to the aiming beam. Default = Off.

No Read

With No Read turned On, the scanner notifies you if a code cannot be read. If using an
EZConfig-Scanning Tool Scan Data Window (see page 159), an "NR" appears when a code
cannot be read. If No Read is turned Off, the "NR" will not appear. Default = Off.
If you want a different notation than "NR," for example, "Error," or "Bad Code," you can edit
the output message with NRDSTR menu command, such as: NRDSTRError or NRDSTRBad Code

Video Reverse

Video Reverse is used to allow the scanner to read barcodes that are inverted. The Video
Reverse Off barcode below is an example of this type of barcode. Scan Video Reverse Only to
read only inverted barcodes. Scan Video Reverse and Standard Barcodes to read both types
of codes.
Note: After scanning Video Reverse Only, menu barcodes cannot be read. You must scan Video
Reverse Off or Video Reverse and Standard Barcodes in order to read menu barcodes.
HH1800 User Guide
On
On
* Off
* Off
51