Show Data Format; Add A Data Format - Honeywell HH1800 User Manual

If you have changed data format settings, and wish to clear all formats and return to the
factory defaults, scan the Default Data Format code below.

Show Data Format

Scan the barcode below to show current data format settings.

Add a Data Format

Step 1.
Step 2.
Step 3.
Note: 099 indicates all terminal types.
Step 4.
60
Scan the Enter Data Format symbol
Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate formats.
This allows you to save a total of 4 different data formats. To program your primary
format, scan 0 from the
programming an alternate format, scan 1, 2, or 3, depending on which alternate
format you are programming. (See
further information.)
Terminal Type
Refer to Terminal ID Table
Scan three numeric barcodes from the
to program the scanner for your terminal ID (you must enter 3 digits). For example,
scan 0 0 3 for an AT wedge.
Code I.D.
In the Symbology Charts,
want to apply the data format. Locate the Hex value for that symbology and scan
the 2 digit hex value from the
If you wish to create a data format for all symbologies, with the exception of some
specific symbologies, refer to B8
If you are creating a data format for Batch Mode Quantity, use 35 for the Code I.D.
* Default Data Format
Data Format Settings
(page 61).
Programming Chart, beginning on page 211. If you are
Primary/Alternate Data Formats
(page 62) and locate the Terminal ID number for your PC.
Programming Chart,
beginning on page 200, find the symbology to which you
Programming Chart,
(page 76).
on page 78 for
beginning on page 211,
beginning on page 211.
HH1800 User Guide