Installing X330-20Gtx And X330-28Gtx Switches On A Concrete Wall - Allied Telesis x330 Series Installation Manual

Chapter 7: Installing x330-20GTX and x330-28GTX Switches on a Wall

Installing x330-20GTX and x330-28GTX Switches on a Concrete Wall

92
This section contains instructions for installing x330-20GTX and x330-
28GTX Switches on a concrete wall with the AT-BRKT-J24 wall brackets
kit. Review "Installation Guidelines" on page 86 before performing the
procedure:
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
 E94
Warning
The device should be installed on the wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is improperly fastened to the wall. 
E105
To install the switch on a concrete wall, perform the following procedure:
1. Place the switch on a table.
Note
If the bumper feet are attached to the bottom on the switch, remove
them before continuing.
2. Install the four AT-BRKT-J24 wall brackets to the sides of the unit, with
the sixteen M4x6mm screws included with the brackets. Refer to
Figure 53 on page 90.
3. Unpack the AT-BRKT-J24 wall brackets kit and verify the contents.
Refer to Figure 22 on page 53.
4. Have another person hold the switch on the concrete wall at the
selected location for the device while you use a pencil or pen to mark
the wall with the locations of the four screw holes in the four brackets
(one screw per bracket). Follow these guidelines when positioning the
switch on the wall:
You can install the switch with the front panel facing up, left, or

right, Figure 55 on page 93 shows the switch with the faceplate on
the left.