Installing The X330-28Gtx Switch; Figure 39: Attaching The Equipment Rack Brackets To The X330-28Gtx Switch - Allied Telesis x330 Series Installation Manual

Installing the x330-28GTX Switch

This section contains the procedure for installing the x330-28GTX Switch
in a standard 19-inch equipment rack with the two equipment rack
brackets included with the device. Here are the required items:
Two equipment rack brackets (included with the switch).

Six M4x8mm bracket screws (included with the switch).

Cross-head screwdriver (not provided).

Four standard equipment rack screws (not provided).

To install the x330-28GTX Switch in a 19-inch equipment rack, perform the
following procedure:
1. Place the switch on a table.
2. If the bumper feet are attached to the bottom of the switch, remove
them before continuing.
3. Attach the equipment rack brackets to the sides of the switch with the
six 4x8mm screws included with the device. Refer to Figure 39.
Figure 39. Attaching the Equipment Rack Brackets to the x330-28GTX
4. Have another person hold the switch at the selected location in the
equipment rack while you secure it using four standard equipment rack
screws (not provided). Refer to Figure 40 on page 74.
5. Go to Chapter 8, "Verifying the Switch" on page 95.
x330 Series Installation Guide for Standalone Switches
Switch
73