Figure 63: Management Workstation, Vt-Kit3 Management Cable, And Switch; Figure 64: Connecting The Management Cable To The Console Port - Allied Telesis x330 Series Installation Manual

Figure 63. Management Workstation, VT-Kit3 Management Cable, and
For instructions on how to start a remote management session, refer to the
x330 Series Software Reference for AlliedWare Plus Operating System.
To start a local management session with the management cable included
with the switch, perform the following procedure:
1. Power on the x330 Switch. Refer to "Powering On the Switch" on
page 96.
2. Wait one minute for the switch to start the AlliedWare Plus
management software.
3. Connect the RJ-45 connector on the management cable to the
Console port on the front panel of the switch. Refer to Figure 64.
Figure 64. Connecting the Management Cable to the Console Port
4. Connect the other end of the cable to an RS-232 port on a terminal or
personal computer with a terminal emulation program.
x330 Series Installation Guide for Standalone Switches
Switch
99