Agilent Technologies PSG Series Service Manual page 236

Post-Repair Procedures
Post-Repair Procedures Matrix
Table 4-2 Adjustments for Assemblies A21 through A32, B1, and RF Output Connector
Adjustments Replaced Assembly
The following adjustments are listed in
the order that they should be performed
for proper calibration.
ADC Calibration
YIG-Driver Pre-Tune Calibration
VCO Bias Frac-N Calibration
Internal Source Calibration
AM Audio Path Offset Calibration
KV vs. Frequency Calibration
Timebase Calibration
FM Scale Offset Calibration
FM Path Offset Calibration
FM In-band Offset Calibration
FM Inverting Amplifier Offset Calibration
FM 1/2 Path Ratio Gain Calibration
Mod Source Relative Gain Calibration
FM/PM Out-of-Band Calibration
FM/PM YO Frequency Compensation Calibration
DC FM Calibration
Low Frequency Output Calibration
External Input Peak Detector Calibration
ALC Dynamic Calibration
Power Flatness Calibration
Attenuator Calibration, Low Band and High Band Power
Attenuator Calibration, High Band and High Power
Attenuator Calibration, Low Band and Low Power
Attenuator Calibration, High Band and Low Power
ALC Modulator Calibration
AM Gain Calibration
Gain Adjustment Bypass Calibration
(Frequencies </= 3.2 GHz)
Pulse Width Calibration
4-3