Siemens SIRIUS 3RK3 Equipment Manual page 251

• Group warning (for MSS 3RK3 Basic only)
(e.g., wait for startup test)
• Group prewarning (not in the case of MSS 3RK3 Basic)
(e.g., wait for startup test)
(e.g., safety sensor triggered)
Parameterization or configuration error
This category of error only occurs in configuring mode. This error is caused if the configuration
is either not available or is incorrect, for example.
Display on the central unit
LED
DEVICE
SF
SIRIUS 3RK3 Modular Safety System
Equipment Manual, 07/2020, NEB926253002000/RS-AC/006
Display on the central unit
LED Display
DEVICE Depending on the operat‐
ing state
SF -
The warning is signaled when the LEDs
of the corresponding inputs start flash‐
ing.
Display on the central unit
LED Display
DEVICE Depending on the operat‐
ing state
SF -
The warning is signaled when the LEDs
of the corresponding inputs start flash‐
ing.
Display on the central unit
LED Display
DEVICE Depending on the operat‐
ing state
SF -
The LEDs of the relevant inputs do not
light up.
Display
Yellow
red
Remedy
Acknowledgment is not necessary. When the logic is cor‐
rect, the warning is automatically canceled.
Remedy
Acknowledgment is not necessary. When the logic is cor‐
rect, the warning is automatically canceled.
Remedy
Acknowledgment is not necessary. When the logic is cor‐
rect, the warning is automatically canceled.
Remedy
Acknowledgment is not necessary. When the parameteriza‐
tion is correct, the error is automatically canceled.
Diagnostics / service
7.2 Diagnostics concept
251