Ups System Output - Eaton 93E G2 100/100 User And Installation Manual

Eaton 93E Generation 2 UPS 100-200 kVA
(380/400/415V)
Item
Battery charging capacity
Battery type
Battery quantity
Recharge profile
End of discharge voltage
9.3
Table 26: UPS output
Item
Number of output phases
Output voltage regulation
Nominal output voltage
Output voltage distortion, uTHD
Output current
Output voltage balance
Output voltage phase displacement
Rated output frequency
Frequency variation
Synchronous to bypass
Frequency slew rate
Load power factor (permitted range)
©
Eaton Corporation plc 2019. All rights reserved.

UPS system output

Value
20 A/100 kVA
Note: The input voltage has also
impact to the maximum charging
current. With the input voltage level
of 220 V and 100% load the maxi-
mum charging current is lower than
20 A.
VRLA (valve regulated lead acid), 12 VDC
36 (216 cells), 38 (228 cells) or 40 (240
cells) blocks
Note: Do not connect battery
strings with different battery quanti-
ty and voltage in parallel!
ABM or float charge
1.85 V/cell for 36 blocks
1.75 V/cell for 38 blocks
1.67 V/cell for 40 blocks
Value
3 phases, N
± 1% (10% to 100% load)
380 Vac, 400 Vac and 415 Vac nominal
< 2% maximum THD (linear load)
11
See Table
< 1% for 100% maximum load imbalance
(linear load)
< 1.5° for 100% maximum load imbalance
(linear load)
50 or 60 Hz, user configurable
± 0.1 Hz free running
± 4 Hz (default setting)
3 Hz per second (default setting)
0.9 p.f. Leading
0.7 p.f. Lagging
Revision: 002 Document ID: P-164000848
User's and installation guide
.
108 (118)