Eaton 93E Generation 2 UPS 100-200 kVA
(380/400/415V)
Do not install or operate the UPS system close to gas or electric heat
sources. Keep the operating environment within the parameters stated in this
document.
Keep the surroundings of the UPS uncluttered, clean, and free from excess
moisture.
Observe all DANGER, CAUTION, and WARNING notices affixed to the inside
and outside of the equipment.
2.1
The intended audience of this document are as follows:
•
People who plan and perform the installation of the UPS
•
People who use the UPS
This document provides guidelines for how to check the UPS delivery and how
to install and operate the UPS.
The reader is expected to know the fundamentals of electricity, wiring, electrical
components and electrical schematic symbols. This document is written for a
global reader.
Read this document before you start to operate or perform work on the UPS.
2.2
The product has a CE marking in compliance with the following European
directives:
•
LVD Directive (Safety) 2014/35/EU
•
EMC Directive 2014/30/EU
•
RoHS Directive 2011/65/EU
Declarations of conformity with UPS harmonized standards and directives EN
62040-1 (Safety), EN 62040-2 (EMC) and EN 50581 (RoHS) are available at
www.eaton.eu or by contacting your nearest Eaton office or authorized partner.
2.3
The only permitted user operations are as follows:
•
Startup and shutdown of the UPS, excluding the commissioning startup.
©
Eaton Corporation plc 2019. All rights reserved.
Audience
CE marking
User precautions
CAUTION
CAUTION
Revision: 002
Document ID: P-164000848
User's and installation guide
12 (118)