Figure 2: Ucm6301 Back View; Figure 3: Ucm6301 Front View - Grandstream Networks UCM630 Series User Manual

To set up the UCM6301, follow the steps below:
1. Connect one end of an RJ-45 Ethernet cable into the WAN port of the UCM6301.
2. Connect the other end of the Ethernet cable into the uplink port of an Ethernet switch/hub.
3. Connect the 12V DC power adapter into the 12V DC power jack on the back of the UCM6301. Insert the
main plug of the power adapter into a surge-protected power outlet.
4. Wait for the UCM6301 to boot up. The LCD in the front will show the device hardware information when the
boot process is done.
5. Once the UCM6301 is successfully connected to network, press the Home button to display the IP address.
6. (Optional) Connect PSTN lines from the wall jack to the FXO ports; connect analog lines (phone and Fax)
to the FXS ports.
Note:

The ground screw needs to be connected.

The same steps will be used in order to connect UCM6302/6304/6308
WAN port
Heartbeat port
FXO port
Reset FXS port
LAN port

Figure 2: UCM6301 Back View

Figure 3: UCM6301 Front View

UCM630X Series User Manual
Version 1.0.2.25
Ground
USB port
SD card slot
P a g e | 33