Trunk Groups; Table 60: Iax Peer Trunk Configuration Parameters - Grandstream Networks UCM630 Series User Manual

Basic Settings
Provider Name
Host Name
Keep Trunk CID
Disable This Trunk
Caller ID
CallerID Name
Advanced Settings
Codec Preference
Enable Heartbeat
Detection
Heartbeat Frequency
Maximum Number of
Call Lines
FECC

Trunk Groups

Users can create VoIP Trunk Groups to register and easily apply the same settings on multiple accounts within
the same SIP server. This can drastically reduce the amount of time needed to manage accounts for the same
server and improve the overall cleanliness of the web UI.

Table 60: IAX Peer Trunk Configuration Parameters

Configure a unique label to identify this trunk when listed in outbound rules,
inbound rules etc.
Configure the IP address or URL for the VoIP provider's server of the trunk.
If enabled, the trunk CID will not be overridden by extension's CID when the
extension has CID configured. The default setting is "No".
If selected, the trunk will be disabled.
Configure the Caller ID. This is the number that the trunk will try to use when
making outbound calls. For some providers, it might not be possible to set the
CallerID with this option and this option will be ignored.
Important Note: When making outgoing calls, the following priority order rule will
be used to determine which CallerID will be set before sending out the call :
CID from inbound call (Keep Original CID Enabled)  Trunk Username/CallerID
(Keep Trunk CID Enabled)  DOD  Extension CallerID Number  Trunk
Username/CallerID (Keep Trunk CID Disabled)  Global Outbound CID..
Configure the name of the caller to be displayed when the extension has no
CallerID Name configured.
Select audio and video codec for the VoIP trunk. The available codecs are: PCMU,
PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, iLBC, ADPCM,
H.264, H.265, H.263, H.263p and VP8.
If enabled, the UCM630X will regularly send SIP OPTIONS to the device to check
if the device is still online. The default setting is "No".
When "Enable Heartbeat Detection" option is set to "Yes", configure the interval
(in seconds) of the SIP OPTIONS message sent to the device to check if the device
is still online. The default setting is 60 seconds.
The maximum number of concurrent calls using the trunk. The default settings 0,
which means no limited.
Configure to enable Far-end Camera Control
UCM630X Series User Manual
Version 1.0.2.25
P a g e | 181