Enable Spy - Grandstream Networks UCM630 Series User Manual

3. To stop the recording, enter the "Start/Stop Call Recording" feature code (by default it is *3) followed by # or
SEND again. Or the recording will be stopped once the call hangs up.
4. The recording file can be retrieved under Web GUICDR. Click on
click on to download the recording file.
The above recorded call's recording files are also listed under the UCM630X Web GUICDRRecording
Files.

Enable Spy

If "Enable Spy" option is enabled, feature codes for Listen Spy, Whisper Spy and Barge Spy are available for
users to dial from any extension to perform the corresponding actions.
Assume a call is on-going between extension A and extension B, user could dial the feature code from extension
C to listen on their call (*54 by default), whisper to one side (*55 by default), or barge into the call (*56 by default).
Then the user will be asked to enter the number to call, which should be either side of the active call, extension
A or B in this example.
---------------------------------------------------------------------------------------------------------------------------------------------------
Caution:
"Enable Spy" allows any user to listen to any call by feature codes. This may result in the leakage of user privacy.
---------------------------------------------------------------------------------------------------------------------------------------------------
Figure 207: Download Recording File from CDR Page
Figure 208: Download Recording File from Recording Files Page
UCM630X Series User Manual
Version 1.0.2.25
to show and play the recording or
P a g e | 306