Status Bar - NAVIS NavDP 4000 Series Operation Manual

Operator Interface
5.12.4.3 Thrust Ability Diagram
Operating in the DP mode the bottom left console contains the Thrust Ability Diagram view (see Figure 5.55).
Operating in the AP mode instead of the plot the rudders and propellers data are displayed (see Figure 5.56).

5.12.5 Status Bar

The status bar is not displayed if the Mode Selector is in the Off position.
In other cases the status bar indicates the following data:
– Control mode(DP, AP, IJ);
– Heading mode (AUTO, MAN, Target, LS Track, Min Power, Dodge);
– Position mode (AUTO, MAN, Hold Area, Target, LS Track, MAN Surge, MAN Sway, Speed Vect);
– AWC status (displayed if only status is ON);
– Remote COR (displayed if only the COR is different from the center);
– TAL Mode (Synch Mode, High BIAS, Low BIAS, No BIAS).
Some examples of the status bar are represented on the Figures 5.57, 5.58.
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
Figure 5.55: Thrust Ability Diagram (DP Mode)
Figure 5.56: The Rudders and Propellers Data (AP mode)
Figure 5.57: Status Bar in the AP Mode
Figure 5.58: Status Bar in the DP Mode
98