Table of Contents
Advertisement
– wait for "Operation 'Unmount removable drive' completed successfully" message.
– disconnect USB flash drive from USB port.
– press "Close" button.
2.3. To start NAVIS NavDP 4000 press "Start DP" button (see Section 3.1, page 50).
2.4. To shut down NAVIS NavDP 4000 use a normal shut down procedure (see Section 3.6, page 55).
G.2.4 Creating Feedback Package
2.1. Switch DP/IJ control computer into "Service Mode" (see Section G.2.2, page 311).
2.2. Press "Feedback" item in "Services" menu.
2.3. In "Feedback List" window press "Create New Feedback" item (use arrow buttons for navigation).
2.4. In "Edit feedback name" window (see Figure G.16):
2.4.1 Change feedback name using a screen keyboard (default name is "new feedback").
2.4.2 Press"OK" button.
2.5. Wait for "Operation 'Add feedback to archive' completed successfully" message.
2.6. Press "Close" button.
2.7. Next, if feedback package was created successfully DPShell suggests you to copy feedbacks to USB flash drive. If
you don't want to copy feedback right now just press "Cancel" button, otherwise you should make sure that USB
flash drive is connected and act the same manner as in section G.2.5, page 313, item 2.5.3.
NOTE!
"Description" field in "Feedback List" window may contain additional
description of the feedback package (for example, "Automatically cre-
ated Feedback"). Editing of this field is unavailable.
G.2.5 Copying Feedback Package to USB Flash Drive
2.1. Switch DP/IJ control computer into "Service Mode" (see Section G.2.2, page 311).
2.2. Insert USB flash drive into DP/IJ control computer USB port.
2.3. Wait for item "Unmount USB" will turn red.
2.4. Press "Feedback" item in "Services" menu
2.5. In "Feedback List" window:
313
Figure G.16: DPShell. Creating feedback
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
NAVIS NavDP 4000. Operation Manual
Advertisement
Table of Contents
