NAVIS NavDP 4000 Series Operation Manual page 230

– Setpoint Heading –– No indicates that system is not ready for consequence calculation.
That is the case when vessel went out from set heading limits. This status would not happened when vessel changes
heading and yet not gets to new set heading.
The DP2/Off softkey switches the function ON and OFF. The action needs to be approved by the ENTER softkey.
The current analysis process and the function state is displayed near the DP2/Off softkey.
In case the function is deactivated, the updating of information is stopped.
The following cases are possible:
1. The function is not active, the process is stopped.
softkey Off
message Stopping
2. The function is active, the process is stopped.
The causes are the following:
– the system does not operate in the automatic modes AutoHDG and AutoPOS;
– or the vessel is moving to new set point;
– or the vessel is beyond set position/heading limits.
Switch to the automatic modes or set heading and/or position values close to the present ones.
softkey DP2
message Stopping
Figure 10.86: The consequence analysis function is active but some conditions are not fulfilled
3. The function is active, the process is running
softkey DP2
message Running
The window (see figure 10.88) contains the system components list and the list of their possible failures.
The system component list
The following information is displayed in the list:
1 — the failure effect indicator;
2 — indicator of the component state in the system;
3 — component name, list;
4 — thrust limits for thrusters, power limits for power components (the values are set in the Param window) and tie
breaker states.
Indicators are color-coded.
229
Figure 10.85: The consequence analysis is stopped
Figure 10.87: Teh consequence analysis is active
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
NAVIS NavDP 4000. Operation Manual