Logging To External Vdr - NAVIS NavDP 4000 Series Operation Manual

– select parameters relating to data properties (angle, moment, speed, etc) from "Data Type" list (see figure
H.24):
"Reset" softkey returns default value "Undefined". A full list of sensor parameters is displayed in "Selected
data" window;
– select required sensor parameters (see figure H.23) according to selected data parameters.
The charts will be plotted according to both types of selected parameters (data and sensors);
– select column and row numbers to which the selected chart will be added (use arrows at the bottom side of the
window for navigation);
– press "OK" softkey;
– chart with selected parameters will appear in the selected column and row.
4.2. When you select "Position plot" item a window in which position parameters are selected for the charts will appear
(see figure H.25).
In the opened window:
– select required position parameters;
– select one of additional parameters from the list to be displayed on the chart (course, roll, pitch, etc).
Additional parameters are available not for all position parameters;
– select column and row numbers to which the selected chart will be added (use arrows at the bottom side of the
window for navigation);
– press "OK" softkey;
– chart with selected parameters will appear in the selected column and row.
Press either "Event table" or "Record table" item and "OK" softkey to add the required table (see Section H.4.4).
H.5 Logging to External VDR
NAVIS NavDP 4000 system allows data transmission to the external VDR.
The data include information such as: position, speed, angles, alarms, etc.
The message contains the following mandatory configurable parameters:
– Talker Identifier (Talker ID) - the first 2 or 4 characters following the "$":
– 2 characters for standard NMEA-messages;
– 4 characters for proprietary messages (with first letter "P").
339
Figure H.25: Position Plot
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
NAVIS NavDP 4000. Operation Manual