Installing Update Package On Control Computer - NAVIS NavDP 4000 Series Operation Manual

1.3. Make sure that correct SW versions are installed on all DP/IJ control computers (see Warning note below).
To obtain information about NAVIS NavDP 4000 active version, follow steps as in Section G.1.9, page 308.
WARNING!
NOTE!
1.4. NAVIS NavDP 4000 is ready to run with updated software.
G.1.8 Installing Update Package on Control Computer
All registered SW updates are logged in the DPShell utility (see Figure G.8). All necessary information about the
updates is available in "Update & Service" menu item, in the "Description" window.
1.1. Switch DP/IJ control computer into "Service Mode" (see Section G.1.1, page 302).
1.2. Insert USB flash drive with installed Update Package into DP/IJ control computer USB port. Wait for item "Un-
mount USB" will turn red.
1.3. Press "Update & Service" item in "Services" menu:
– wait for "Available updates List" window will appear (see Figure G.8). This operation may take up to several
minutes;
– select required Update Package. Use arrow buttons for navigation.
1.4. Press "Execute" button:
– wait for a message "Operation Update DP-version with package ... completed successfully";
– press "Close" button.
1.5. Update Package selected in 1.3 item is installed on control computer.
307
For DP-2 class systems the same SW version should be installed
on both CCA and CCB control computers.
Never use NAVIS NavDP 4000 in case of different versions are
active on DP/IJ control computers!
SW versions installed on DP and IJ computers may vary.
Figure G.8: DPShell. Update package installing
NAVIS NavDP 4000. Operation Manual
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"