Modes And Functions; Values Setting In The Autopos And Hdg Modes; Cp Orientation - NAVIS NavDP 4000 Series Operation Manual

Operator Interface

5.12.7 Modes and Functions

See Section 2.4.17, page 31

5.12.8 Values Setting in the AutoPos and HDG Modes

Operating in the AutoPos mode the the operator can set the surge and sway values using the encoder and the arrow
push buttons.
The setting dialog (see Figure 5.59) is activated by pushing the the POS button or any arrow button. The control is
provided by arrow buttons.
To delegate control to the encoder press the encoder when the dialog is active. After control is delegated encoder
rotation is used to change the values. To select the value or to switch between the values press the encoder.
The HDG dialog is activated in similar way pushing the HDG button or a Knob Match indicator. The control is
provided by the Knob Match indicators.
As for the POS dialog the control is delegated to the encoder by pressing the encoder when the dialog is active. Rotate
the encoder to set a new HDG value and press the encoder to approve the value.
To set values with the arrows push buttons press any arrow button. The arrow indicators near the "Surge" and "Sway"
items switch from gray to colored (see Figure 5.60).

5.12.9 CP Orientation

There are four orientations allowed for CP: forward, aft, port and starboard. This is adjusted in DP System during
installation and commissioning.
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
Figure 5.59: Setting with the Encoder
Figure 5.60: Setting with the Arrows Buttons
100