A Synchronized/Independent Modes For Dp-2 Systems (Visual) - NAVIS NavDP 4000 Series Operation Manual

Synchronized/Independent Modes for DP-2 Systems (Visual)
Appendix A
Synchronized/Independent Modes for DP-2
Systems (Visual)
There are two sort of system configuration considering the Synchronization mode:
– the Syncronized mode is available to switch to the Independent one and vice versa
– Synchronized in the only mode, the switching is not available
When operating in the Independent mode changes are applied for the station where they were performed only.
When operating in Synchronized mode the most of parameters changes are available on the Master station only. Some
exclusions aredescribed below.
All tabs of the PARAM window are available to switch between on the Slave station. But the most of values are not
available to change on the Slave station when operating in synchronized mode. The exclusions that can be changed for
the every work station in any mode are the following:
– The operations on the Logging tab is an independent operation
– Palette settings changing is the synchronized operation
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
250