NAVIS NavDP 4000 Series Operation Manual page 90

Switching via the Param Window
Press the Change softkey for parameter Windows Sync Mode on the Param
value has been changed press the Apply softkey to switch the mode or Cancel softkey to hold on the current one.
Switching the Mode via Icon
The mode switching is available without using the Param window. Press the icon indicating the current mode(see
figure 5.36). The switching dialog appears (Fig. 5.38).
PressYes to switch the mode or No to hold on the current one.
89
(a) Independent (b) Synchronized
Figure 5.36: The current mode indicator
Figure 5.37: The setting mode on the System tab
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
NAVIS NavDP 4000. Operation Manual
System tab (see figure 5.37). After the