NAVIS NavDP 4000 Series Operation Manual page 253

Alarm Messages List
Error Clearing PLC Faults failed
Warning Enabling PLC Faults failed on slave
Warning Disabling PLC Faults failed on slave
Error Enabling PLC Faults failed
Error Disabling PLC Faults failed
Info PLC Faults enabled
Info PLC Faults disabled
Error Main DP System Error
Error Backup DP System Error
Error Lost all WS
Error Lost active WS
Error Signal-Controller redundant network error
Error AP Fault - Switch To Manual Steering
Error Low Speed - Switch To Manual Steering
Error AP Speed REF Failed. Switch to Manual
Speed
Error AP Heading - No Valid Data
Error AP Steering Failed
Error AP - Off Heading
Error Heading Monitor Off
Warning HS Track is Not Approved for Navigation
Warning Track Control not initiated: Too Big Dis-
tance to Track
Warning Track Control not initiated: Too different
angles of Heading and BOD
Warning Active track rejected
Info Active track changed
Info External track loaded
Info External track not loaded
Warning External track not loaded: can not change
active track
Info External track overwritten
Error Error on loading external track
Info Track overwritten because of start synchro-
nization
Error Off Track Limit
Info Track Complete
Info New Way Point
Warning Track trimmed to maximal allowed length
Error The Vessel is about to reach a new Way
point
Info Track: Pause Mode
Error Heading limit excess
Error Position limit excess
Error Position offset program limit excess
Error Vessel outside the hold area
Warning Vessel approaching the hold area border
Error Course outside Min Power sector
Info External DP Setpoint was loaded
Error Set Cartesian coordinates for HPR mes-
sage
Warning UTM zone is too far
Warning UTM coordinates is not applicable
Warning Synchronize knob
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
Clearing PLC Faults failed
Enabling PLC Faults failed on slave
Disabling PLC Faults failed on slave
Enabling PLC Faults failed
Disabling PLC Faults failed
PLC Faults enabled
PLC Faults disabled
Main DP System Error
Backup DP System Error
Lost all WS
Lost active WS
Signal-Controller redundant network error
AP Fault - Switch To Manual Steering
Low Speed - Switch To Manual Steering
AP Speed REF Failed. Switch to Manual
Speed
AP Heading - No Valid Data
AP Steering Failed
AP - Off Heading
Heading Monitor Off
HS Track is Not Approved for Navigation
Track Control not initiated: Too Big Dis-
tance to Track
Track Control not initiated: Too different
angles of Heading and BOD
Active track rejected
Active track changed
External track loaded
External track not loaded
External track not loaded: can not change
active track
External track overwritten
Error on loading external track
Track overwritten because of start synchro-
nization
Off Track Limit
Track Complete
New Way Point
Track trimmed to maximal allowed length
The Vessel is about to reach a new Way
point
Track: Pause Mode
JDP
Heading limit excess
Position limit excess
Position offset program limit excess
Vessel outside the hold area
Vessel approaching the hold area border
Course outside Min Power sector
External DP Setpoint was loaded
Set Cartesian coordinates for HPR mes-
sage
UTM zone is too far
UTM coordinates is not applicable
Synchronize
Synchronize knob
252