NAVIS NavDP 4000 Series Operation Manual page 217

System Functions
Wave
In Auto mode the wave direction matches the wind direction and the wave height is calculated by the system as a
function of the wind speed (see Figure 10.62). In this case Auto softkey is highlighted by white color and Change softkey
is unavailable.
Press the Auto softkey, so the Change softkey becomes available. Press the Change softkey for manual input of the
wave parameters (direction and height).
In the opened dialog box (see Figure 10.68):
– select the wave direction value:
– enter a new value in degrees in the DIR field or
– press Hold softkey to enter present value for the wave direction;
– press H softkey and enter a new value for the wave height in the corresponding field;
– press OK softkey to apply the choice and leave the dialog box. In case incorrect values are entered for the wave
direction/height, OK softkey is unavailable.
Press Cancel softkey to leave the dialog box without any changes.
Figure 10.68: Example of the Dialog Box for Wave Direction/Height Settings
Doc. 000.JDP-10000-OME, rev.3.3.13/"2102.$–17A-Advanced"
The value for wind direction set in the dialog box is displayed under the
Wind text.
Speed var. means that the wind speed can be read on the Capability
Plot.
216