Connecting The Loadstar-S To The Visionguard Visua- Lization Software - Eaton LoadStar-S JSB Mounting And Operating Instruction

7
8
9
10
11
12
16.16. Connecting the LoadStar-S to the Visi-
onGuard visualization software
To connect the LoadStar-S to the VisionGuard, the
LoadStar-S must be connected to the Ethernet via the RJ
45 socket on the ACU module.
All other settings can be found in the 16.14 Connecting
the LoadStar-S to the VisionGuard visualization software.
Mounting- and Operating Instruction Eaton LoadStar-S JSB 40071860396 March 2021 www.ceag.de
Circuit Status
Luminaire Status
IO/3PM-IO Status
ACU Status
ACU Status
Information
Ethernet connection
16.15. Table troubleshooting (Login Operator)
circuit switching
Circuit status:
Battery low
overload
DC fuse error
Backup error AC
ISO+ error
ISO error
communication error
battery interruption
Luminaire fault DC
Luminaire fault AC
I< Imin DC
I< Imin AC
IGBT error
Supply voltage inverted.
Name
Information
Switch 1
Switch 2
type
Category
Nominal power in W
Nominal power in VA
Selection of which module requires a status.
Actuate
type:
Software:
Hardware:
Information for the Service
49