Eaton LoadStar-S JSB Mounting And Operating Instruction page 32

16.1. Table Usergroup
Expert
(Includes all legitimacy of
operator, untrained and
instructed operator plus
system settings)
32
Mounting- and Operating Instruction Eaton LoadStar-S JSB 40071860396 March 2021 www.ceag.de
• Charging-/Battery Status
o Voltage in V, charge-discharge current in A, capa-
city in %, ambient temperature battery set in°C
o Last DT time
o Status Battery Block Monitoring (optional)
o Status Charging modules (CM)
o Software status
o String current (optional)
o Reset deep discharge
o Reset ISO-failure
• Circuit Status
• Luminaire Status
• IO/3PM-IP Status
• ACU Status
o Communication Status
o Relais Status
o Status Inputs
• PSU Status
• Group device state
o Total pup
o search devices
• Menu
o Get service information.
o Load and save device configuration via USB
- Copy Config to USB
- Copy Config from USB
- Eject USB
- Select Firmware
- Copy Lum types from USB
• Start FT
• Functions
o Start Duration Test (DT)
o Cancel Functiontest/Duration Test
o Manual reset
o Search ISO failure
o Luminaire search (all modules)
o Learn current values (all Modules)
o deregister ext. modules
o Block device
o Release device
o Simulate mains failure
o FT short forward run
o All luminaires on
o non-maintained luminaires on
o maintained luminaires off
• Basic settings
o Charging/Battery Setting
o Test Settings
o General settings
- System Settings
- Timer Settings
- Relais Module Settings
- HMI Settings
- User Settings
o Log book
o ACU settings
o PSU Settings
o GLT Settings
• Circuit Setup
• Luminaire setup
• I/O Modul Setup