Eaton LoadStar-S JSB Mounting And Operating Instruction page 30

16.1. Table Usergroup
Non-instructed
specialist
(all status and service
information, data up- and
download via USB, endu-
rance test) and basic
settings)
30
Mounting- and Operating Instruction Eaton LoadStar-S JSB 40071860396 March 2021 www.ceag.de
• Charging-/Battery Status
o Voltage in V, charge-discharge current in A,
capacity in %, ambient temperature battery
set in°C
o Last DT time
o Status Battery Block Monitoring (optional)
o Status Charging modules (CM)
o Software status
o String current (optional)
o Reset deep discharge
o Reset ISO-failure
• Circuit Status
• Luminaire Status
• IO/3PM-IP Status
• ACU Status
o Communication Status
o Relais Status
o Status Inputs
• PSU Status
• Group device state
o Total pup
o search devices
• Menu
o Get service information.
o Load and save device configuration via
USB
- Copy Config to USB
- Copy Config from USB
- Eject USB
- Select Firmware
- Copy Lum types from USB
• Start FT
Functions:
o Start Duration Test (DT)
o Cancel Functiontest/Duration Test
o Manual reset
o Search ISO failure
o Luminaire search (all modules)
o Learn current values (all Modules)
o deregister ext. modules
Basic settings
o Charger/Battery Setting
o Test Settings
o General settings
- System Settings
o Log book
• Circuit Setup
• Luminaire setup
• I/O Modul Setup