Eaton LoadStar-S JSB Mounting And Operating Instruction page 27

Subscribe to ACU Module inputs
The inputs of the ACU can also be used on other ACUs.
Again, the inputs must be published on one device and
subscribed on the other. The terminals of the subscribing
Application example for binding functions.
device then no longer have any function. To avoid misbe-
Subscribe ACU inputs
haviour, the subscribed input must be programmed for the
same function.
S1
Luminaires are blocked via
S1
LoadStar-S
Device 1: ACU Bus ID 1
Input 3 published
Subscribe to ACU inputs
Subscribing of 3-PM-IO Modules
Example:
System with one main station (ACU Bus ID: 1) and one
Application example for binding functions.
substation (ACU Bus ID: 2). The modules are published only
by the main station and subscribed in the substation, partly
Subscribe IO/3PM-IO/TLS Module Inputs
on a module place different from the main station.
S1
LoadStar-S
Main distributor device 1: ACU Bus ID 1
3-PM-IO Module 20 published.
Mounting- and Operating Instruction Eaton LoadStar-S JSB 40071860396 March 2021 www.ceag.de
Device 2: From ACU Bus ID 1
Input 3 subscribed
© 2017 Eaton. All Rights Reserved..
Luminaires are switched on
via S1.
Sub-distribution board device 2: ACU Bus ID 2
3-PM-IO Module 20 subscribed.
© 2017 Eaton. All Rights Reserved..
Luminaires are blocked via
S1 and the ACU DG.
LoadStar-S
Luminaires are switched on
via S1 and the ACU DG
bus.
LoadStar-S
16 Device Configuration
1
2
27