6�6�8�- Digital Output Manual Operation - Circutor Line-CVM-D32 Instruction Manual

Hold down key
Hold down key
Use keys
Press key
 Pulse width:
Minimum value: 0 x10 ms.
Maximum value: 999 x10 ms.
Hold down key
Use key
6�6�8�- DIGITAL OUTPUT MANUAL OPERATION
Note: Screen displayed if the selected digital output variable is MANUAL, see
This screen enables manual digital output activation.
Hold down key
Use keys
OFF, Disconnected output.
ON, Connected output.
Hold down key
Use keys
NC, Contact normally closed.
NO, Contact normally open.
Hold down key
Use key
68
to set pulse width to a high level
to set pulse width to a low level
and to modify the digit's value.
to skip through the digits.
to validate the value.
to skip to the next programming point.
to set output status
and to skip through the different options:
to set contact status
and to skip through the different options:
to validate the value.
to skip to the next programming point.
HIGH PERIOD
0
x10
ms
LOW PERIOD
0 x10
ms
OUT1
SETUP
(HIGH PERIOD)
(LOW PERIOD)
STATUS
OFF
CONTACT TYPE
NO
OUT1
SETUP
RATIOS
(STATUS)�
.
(CONTACT TYPE)
.
.
Table 12.
Instruction Manual
line-CVM-D32