6�6�5�- Latch - Circutor Line-CVM-D32 Instruction Manual

value in %.
Use keys
Press key
 Hysteresis:
Minimum value: 0%.
Maximum value: 99%.
Hold down key
Use keys
NC, Contact normally closed.
NO, Contact normally open.
Hold down key
Use key
6�6�5�- LATCH
Note: Screen visible if the selected digital output variable is in
This screen enables alarm latching configuration.
Hold down key
if the event that triggered it disappears.
Use keys
NO, Latching is not activated.
YES, Latching is activated.
TIME, Alarm latching is activated for a set time, Latching time.
Hold down key
displayed. After such time, if the alarm status no longer applies, disconnection delay is
Use keys
Press key
 Latching time:
Minimum value: 0 s.
66
and to modify the digit's value.
to skip through the digits.
to set contact status
and to skip through the different options:
to validate the value.
to skip to the next programming point.
to set latching
(LATCH)
and to skip through the different options:
to set Latching time
and to modify the digit's value.
to skip through the digits.
.
(CONTACT TYPE)
Table 10
LATCH
NO
TIME ON
0
S
OUT1
SETUP
, i.e. if it remains interlocked after the alarm is triggered, even
. The time in seconds that the alarm is interlocked is
(TIME ON)
line-CVM-D32
, Table 11, or
Table 12 Table 13.
activated.
Instruction Manual