6�6�- Configuration Of Digital Outputs 1 And 2; 6�6�1�- Variable - Circutor Line-CVM-D32 Instruction Manual

Use keys
Press key
Hold down key
 Tariff 3 and 4 ratio per kWh in generation
Minimum value: 0.00000 EUR
Maximum value: 99.99999 EUR
Use key
6�6�- CONFIGURATION OF DIGITAL OUTPUTS 1 AND 2
Note: Digital output 1 configuration is identified by the literal OUT1 at the bottom right-hand side of
the display. Literal OUT2 corresponds to digital output 2.
6�6�1�- VARIABLE
This screen enables configuration of the digital output variable
Hold down key
Use keys
Press key
The codes for the variables are shown in
To validate the option, hold down key
Use key
Phase-Neutral voltage
Phase-Phase voltage
Current
Frequency
Total Active Power
Consumed Active Power
Generated Active Power
60
and to modify the digit's value.
to skip through the digits.
to validate the value.
to skip to the next programming point.
to enter programming mode.
and to modify the digit's value.
to skip through the digits.
to skip to the next programming point.
Table 10: Variable codes for Digital Output programming (Table 1)�
Parameter
VARIABLE
1
V1
OUT1
SETUP
Table 10, Table 11, Table 12, Table 13
.
Phase Code Phase
L1 1 L2
28
L12 L23
L1 2 L2
- 27 -
3
L1 L2
L1 700 L2
728
L1 L2
.
(VARIABLE)
and
Table 14�
Code Phase Code
9 L3 17
29 30
L31
10 L3 18
- - -
11 19
L3
707 L3 714
735 742
L3
Instruction Manual
line-CVM-D32
Phase Code
III 31
32
III
III 33
- -
34
III
III 721
749
III