Adjusting The Transport Lights - MacDon R85 Operator's Manual

3.12 Adjusting the Transport Lights

The transport lights, which are mounted on both ends of the header, are activated by switches in the M-Series and
M1-Series windrower cab. Refer to your windrower operator's manual on when to use them. The reflectors can be
reversed, depending on the direction of travel. The amber deflector must face the direction of travel.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
Change the amber reflector (A) orientation as follows:
NOTE:
Arrow indicates direction of travel (B).
1. Disconnect wiring harness (C) at light.
2. Remove four bolts (D) and then remove light
assembly (E).
NOTE:
Only two bolts shown in illustration.
3. Repeat for opposite light assembly.
4. Swap locations of light assemblies (E).
5. Reinstall light assemblies (E) so that amber reflector
faces in opposite direction from original installation.
6. Reinstall bolts (D) and connect light to wiring
harness (C).
214014
OPERATION
Figure 3.103: Transport Light Assembly
Figure 3.104: Transport Light Assembly
82
Revision B