Preseason/Annual Service; End-Of-Season Service - MacDon R85 Operator's Manual

5.3.2 Preseason/Annual Service

CAUTION
• Review the operator's manual to refresh your memory on safety and operating recommendations.
• Review all safety signs and other decals on the header and note hazard areas.
• Be sure all shields and guards are properly installed and secured.
safety equipment.
• Be sure you understand and have practiced safe use of all controls. Know the capacity and the operating
characteristics of the machine.
• Check the first aid kit and fire extinguisher. Know where they are and how to use them.
Perform the following at the beginning of each operating season:
• Lubricate machine completely. Refer to
• Perform all annual maintenance. Refer to

5.3.3 End-of-Season Service

CAUTION
Never use gasoline, naphtha, or any volatile material for cleaning purposes. These materials may be toxic
and/or flammable.
Do the following at the end of each operating season:
• Clean the header thoroughly.
• Store in a dry, protected place if possible. If stored outside, always cover the header with a waterproof canvas or
other protective material.
• Raise the header and engage header safety props.
• If possible, block up the header to take weight off tires.
• Repaint all worn or chipped painted surfaces to prevent rust.
• Loosen drive belt.
• Lubricate the header thoroughly, leaving excess grease on fittings to keep moisture out of bearings.
• Apply grease to exposed threads, cylinder rods, and sliding surfaces of components.
• Oil cutterbar components to prevent rust.
• Check for worn components and repair as necessary.
• Check for broken components and order replacements from your Dealer. Attention to these items right away will
save time and effort at beginning of next season.
• Replace or tighten any missing or loose hardware. Refer to
• Remove divider rods (if equipped) to reduce space required for inside storage.
214014
MAINTENANCE AND SERVICING
5.3.4 Lubrication and Servicing, page
5.3.1 Maintenance Schedule/Record, page
124
125.
8.1 Torque Specifications, page
Never alter or remove
121.
185.
Revision B