Returning Tall Crop Feed Plates To Storage - MacDon R85 Operator's Manual

3. Remove feed plate (A).
4. Return feed plates to storage.
Returning Tall Crop Feed Plates to Storage, page
5. Install the deflector. Refer to
Deflector, page 151.
6. Close the cutterbar doors.
Doors, page 33.

4.11.3 Returning Tall Crop Feed Plates to Storage

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
1. Lower the header fully.
2. Stop the engine and remove the key.
3. Open the right-hand end driveshield. Refer to
4. Remove the four nuts (A) and secure the nut shields (B)
and feed plates (C) to side of compartment. Reinstall
nuts (A).
NOTE:
Nut shields will not be in storage location if they are
installed on the cutterbar.
5. Install right-hand shield. Refer to
Endshield, page 32.
214014
OPERATING THE HEADER
Refer to
4.11.3
106.
Installing the Driveline
Refer to
3.5 Cutterbar
3.4.5 Removing Right Endshield, page
3.4.6 Installing Right
106
Figure 4.32: Tall Crop Feed Plate
Figure 4.33: Nut Deflector and Feed Plate
Storage
32.
Revision B