Attaching Header To An M200 And M205 Self-Propelled Windrower - MacDon R85 Operator's Manual

3.7.2 Attaching Header to an M200 and M205 Self-Propelled Windrower

To attach the header to a self-propelled windrower, follow
these steps:
1. Remove hairpin from pin (A) and remove pin from the
left and right header boots (B).
CAUTION
Ensure all bystanders have cleared the area.
2. Start engine and activate HEADER down button on
the ground speed lever (GSL) to fully retract header
lift cylinders.
3. Slowly drive the windrower forward so that the feet (A)
enter the header boots (B). Continue to drive slowly
forward until feet engage the boots and header nudges
forward.
4. If a manual center-link is installed, raise it up by hand
and extend it until it reaches the header. Install the pin
to secure the center-link to the header.
5. Adjust the manual center-link until a dimension of
737 mm (29 in) (pin to pin) is achieved.
214014
OPERATION
Figure 3.28: Header Boots
Figure 3.29: Header Boots
44
Revision B