Overshot Auger; Adjusting The Overshot Auger - MacDon R85 Operator's Manual

4.13 Overshot Auger

The overshot auger is designed to feed the cut crop from the cutterbar into the conditioner rolls.
The auger position has been factory set and should not normally require adjustment. However, if adjustment is
required the vertical and fore-aft positions of the auger can be adjusted for crop conditions. The ideal setting allows
optimal movement of crop, minimizes wrapping, and keeps the cutterbar clear.
For fine stemmed crop, the auger performs best when set as close as possible to the pan and stripper bars without
rubbing. This is especially important in grass and other crops which have a tendency to wrap.
IMPORTANT:
The auger flighting should NEVER contact the pan or stripper bars.
Component wear may cause excessive clearances resulting in feeding problems and uneven windrows.

4.13.1 Adjusting the Overshot Auger

If necessary, adjust the auger position as follows:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
1. Raise the header fully.
2. Stop the engine and remove the key.
3. Engage header safety props. Refer to
and Disengaging the Header Safety Props, page
4. Remove/loosen four bolts (A) and remove cover (B).
214014
OPERATING THE HEADER
3.3 Engaging
28.
Figure 4.39: Drive Belt Cover
110
Revision B