Safety Signs; Installing Safety Decals - MacDon R85 Operator's Manual

1.6 Safety Signs

• Keep safety signs clean and legible at all times.
• Replace safety signs
become illegible.
• If original parts on which a safety sign was installed are
replaced, be sure the repair part also bears the current
safety sign.
• Safety signs are
Parts Department.

1.6.1 Installing Safety Decals

1. Clean and dry installation area.
2. Decide on exact location before you remove decal backing paper.
3. Remove smaller portion of split backing paper.
4. Place sign in position and slowly peel back remaining paper, smoothing sign as it is applied.
5. Prick small air pockets with a pin and smooth out.
214014
that are missing
available from your
SAFETY
or
Dealer
Figure 1.14: Operator's Manual Decal
7
Revision B