Siemens SINAMICS S150 Operating Instructions Manual page 148

Converter cabinet units 75 kw to 1200 kw

Hide thumbs Also See for SINAMICS S150:

Table of Contents

Commissioning

5.3 Procedure for commissioning via STARTER

The following command and setpoint source options are available:

Command sources:

Setpoint sources:

With SINAMICS S150, only CDS0 is normally used as a default setting for the command and

setpoint sources.

Make sure that the selected default setting is compatible with the actual system

configuration.

You cannot retrospectively change the selected default setting with

< Back (unless the current value is No selection).

If you made an incorrect entry, delete the complete drive unit from the project navigator and

create a new one.

34. Check your default selections carefully and then click Continue >

TM31 terminals

PROFIdrive NAMUR

TM31 terminals

Motorized potentiometer

Fixed setpoint

Drive converter cabinet units

Operating Instructions, 07/07, A5E00288214A