Level 2: Tig Set-Up Parameters; Select "Parameter 2Nd; Accessing; Selecting And Altering The Set-Up Parameter - Fronius TransTig 2200 Operating Instructions Manual

Level 2: TIG set-up parameters

Select
-
"Parameter 2nd"
-
-
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
-
Once the set-up parameter "2nd" has been selected:

Accessing

-
-
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
Selecting and -
altering the set-
up parameter
-
Exiting and -
saving
Available set-up SFS .... Special four-step ... OFF / 1 (Variant 1)
parameters
Variant 1 of the special 4-step operating is described in the section headed: "TIG
operating modes".
C-C ..... Cooling unit control ... (optional) ... AUT / ON / OFF
In the "AUT" position, the coolant return-flow temperature is checked after a 2-minute
weld off-time. If the return-flow temperature is less than 50 °C, the cooling unit is
switched off automatically.
"AUT" position ...... Cooling unit is switched off 2 minutes after the end of welding
"ON" position ........Cooling unit is ON all the time
"OFF" position ...... Cooling unit is OFF all the time
Press the "Mode" button (1) to select either 2-step mode (2) or 4-step mode (3)
(2)
(3)
(1)
While pressing and holding the Store button (13), press the "Mode" button (1)
The first set-up parameter is displayed (e.g. "SPt")
Select the set-up parameter "2nd" with the parameter selection buttons (8) and (9).
While pressing and holding the Store button (13), press the "Mode" button (1)
The first set-up parameter of Level 2 is displayed (e.g. "SFS")
Select the desired set-up parameter with the parameter selection buttons (8) and
(9).
Alter the value of the set-up parameter with the adjusting dial (7)
Press the Store button (13) twice
Factory setting: OFF
Factory setting: AUT
60