Job Mode; General Remarks - Fronius TransTig 2200 Operating Instructions Manual

Job mode

General remarks

"Job Mode" assists the production of reproducible quality, both in manual welding and
also in semi-automatic and fully automated operation.
The traditional way of reproducing often-needed jobs (operating points) was to
document the required parameters by hand. In Job Mode, it is now possible to create,
copy, delete and retrieve up to 100 different jobs.
Another advantage is that the power source is immediately ready for welding, with the
desired parameters. You can also arrange jobs in the order required by the production
sequence. "Grouping" of jobs is also supported (e.g. with reference to different
weldments).
The result is to minimise downtimes while ensuring 100% reproducible quality.
Abbreviations
The following messages may be displayed while you are working with jobs:
---............ No job in this program location (when you attempt to retrieve a job)
nPG ........ No job in this program location (when saving a job)
PrG ......... There is a job in this program location
Pro ......... Job is being copied to this program location
dEL ........ Job is being deleted from this program location
Saving a job The machine comes with no jobs stored in it. Before you can retrieve a job, then, this
job has to be saved to the machine first.
To save a job, proceed as follows:
-
Important! All the settings that are active at this moment in time will be stored as a job.
-
Important! If the selected program location already has a job stored in it, then this
existing job will be overwritten with the new job. This action cannot be undone.
Set the desired welding parameters
Exception: The power-source-specific settings in the Set-up menu: Level 2.
- Briefly press the Store button (13) to
change to the job menu. The machine
suggests the first vacant program
location for the job.
- Select the desired program location
with the adjusting dial (7), or else
leave the suggested program location
unchanged.
- Press and hold the Store button (13).
The left-hand display reads "Pro" -
the job is stored in the program
location you have just selected.
47