Transtig 2200 Control Panel - Fronius TransTig 2200 Operating Instructions Manual

TransTig 2200
control panel
(continued)
(10) Welding current display ... for indicating the welding current for the parameters:
Final current I ...................... 0 to 100 % of main current
E
Electrode diameter ............. 0 to 4.0 mm, factory setting: 2.4 mm
Available parameters where "Job mode" (4) has been selected:
The parameters that apply to the operating mode that has been stored in the
selected job are made available in "Job mode". In addition, the following parameter
is also available:
Job number .......................... for selecting the desired job
Available parameters where the "Rod electrode (MMA) welding" mode (5) has been
selected:
Main current I ...................... TransTig 2200: 10 to 180 A
1
I (starting current)
S
I (main current)
1
I (reduced current)
2
I (final current)
E
Before the start of welding, the left-hand display shows the command value. For I
I and I , the right-hand display also shows the respective %-age of the main
2 E
current I .
1
After the start of welding, the parameter I
display shows the present actual value of the welding current.
The control panel indicates which position has been reached in the welding process
by means of a dimmed display of the parameters (I
Important! If the parameter ACS (see the section headed "Set-up menu: Level 2")
is set to OFF, then the most recently selected parameter remains active during
welding. No automatic selection of parameter I
16
Factory setting: 30 %
is automatically selected. The left-hand
1
, t , ...).
S up
takes place.
1
,
S