Spot Welding - Fronius TransTig 2200 Operating Instructions Manual

Spot welding

For information on setting the "Spot-welding time" set-up parameter (SPt), see the
section headed "The Set-up menu: Level 1".
If a value has been set for the "SPt" set-up parameter, the operating mode "2-step
mode" (2) will have the function of the spot-welding mode.
-
-
-
To abort this procedure, pull back the torch trigger once again.
I
Fig.12 Spot welding
Spot-welding status indicator: Remains lit up as long as a value has been
specified for the spot-welding time.
Select 2-step mode (2)
In the "Set-up menu: Level 1", set the "SPt" set-up parameter to the desired spot-
welding time.
Welding: Briefly pull back the torch trigger
GPr t
up
I
1
SPt
29
t
t G-L
down
G-H