Linking Up The Power Source To The Cooling Unit; Connecting Up The Gas Cylinder - Fronius TransTig 2200 Operating Instructions Manual

Linking up the
(38)
power source to
(39)
the cooling unit
(40)
Fig.9
-
-
-
Fig.10 Fixing-bars for mounting the power source
Connecting up
the gas cylinder
-
-
Plug-type connection between the power
source and the cooling unit
Make a plug connection (39) between the power source and the cooling unit (Fig.9)
Caution! Kinked or otherwise damaged cables can cause short circuits. When
placing the power source on the cooling unit, make sure that you do not kink or
damage the connector plug or the connecting cable.
Carefully place the power source onto the cooling unit (Fig.9)
Using the enclosed screws, bolt the power source to the cooling unit (2 screws at
the front and 2 at the back)
(41)
Caution! Risk of injury from gas cylinder toppling over.
- Always use a safety strap
- Fix the safety strap at the same height as the top part of the cylinder
- Never fix the safety strap around the neck of the cylinder
Fix the gas cylinder to the trolley
Connect up the gas cylinder:
- Take off the protective cap from the gas cylinder
- Briefly turn the gas-cylinder valve anticlockwise, to blow off any dust and dirt
- Inspect the seal on the pressure regulator
- Screw the pressure regulator onto the gas cylinder and tighten it
24
- Shift the mains switch into the "0"
position
- Place the power source onto the
cooling unit:
- Using a suitable hoisting device,
manoeuvre the power source so
that it is suspended over the
cooling unit
- Pull the connector plug (38) of the
power source as far as possible
through the opening on the underside
(Fig.9)
- Carefully place the power source onto
the cooling unit
- Using the screws supplied, bolt the
power source to the cooling unit (2
screws at the front and 2 at the back)
Caution! Risk of injury from
machines toppling over and falling
off the trolley. Check that all the
screw connections on the trolley are
tight.