Saving A Job; Copying A Job - Fronius TransTig 2200 Operating Instructions Manual

Saving a job

(continued)

Copying a job

-
Important! If the selected program location already has a job stored in it, then this
existing job will be overwritten with the new job. This action cannot be undone.
You can copy a job that has already been stored in one program location to any
other program location. To copy a job, proceed as follows:
(4)
(1)
48
- "PrG" appears on the left-hand
display to indicate that the job is now
stored. Release the Store button (13).
- Briefly press the Store button (13) to
exit from the job menu.
- With the "Mode" button (1), select
"Job mode" (4) as the operating
mode. The display now shows the
last job to be used.
- Use the adjusting dial (7) to select
which job you want to copy
- Briefly press the Store button (13) to
change to the job menu. The machine
now suggests the first vacant
program location for the job to be
copied.
- Select the desired program location
with the adjusting dial (7), or else
leave the suggested program location
unchanged.
- Press and hold the Store button (13).
The left-hand display reads "Pro" -
the job is copied to the program
location you have just selected.
- When "PrG" appears on the left-hand
display, the copying operation is
finished. Release the Store button
(13).
- Briefly press the Store button (13) to
exit from the job menu.