Mitsubishi MELSEC L Series User Manual page 73

(2) Applicable solderless terminals
The following table shows applicable solderless terminals for an ERR. terminal of the L6EC-ET.
For wiring method, refer to
Product name
Bar solderless terminal FA-VTC125T9
Tool dedicated for bar
FA-NH65A
*1
solderless terminal
AI0.5-10WH
Bar solderless terminal AI0.75-10GY
AI1-10RD
Tool dedicated for bar
CRIMPFOX UD6-4
*1
solderless terminal
TE0.5-10
Bar solderless terminal TE0.75-10
TE1.0-10
Tool dedicated for bar
NH-79
*1
solderless terminal
*1 Use the same manufacturer for the bar solderless terminal and the tool dedicated for bar solderless terminal.
(a) Precautions for processing the cable end
• To use the bar terminal type with cable cores sticking out of the sleeve, insert the cable so that cable cores
stick out by approximately 0 to 0.5mm from the sleeve edge.
• Check an appearance of the bar terminal after crimping it. Do not use the bar terminal if it is not crimped
properly or the side is damaged.
Page 48, Section 4.3.3.
Model name Applicable wire size
0.3 to 1.65mm
2
0.5mm
0.75mm
2
1.0mm
0.3 to 0.5mm
0.75mm
2
1.0mm
2
Mitsubishi Electric System & Service Co., Ltd.
-
2
Phoenix Contact GmbH & Co. KG
-
2
2
NICHIFU TERMINAL INDUSTRIES CO.,LTD.
-
CHAPTER 8 END COVER
Manufacturer
71
8